Yamaha NS-P430 Owner's Manual - Page 13

English Ⅵ How to connect speaker cables to the input terminals of the speakers For connections, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the connections are faulty, no sound will be heard from the speakers. Main speakers Center speaker Use the provided speaker cables (4 m). One side of the speaker cable is red and the other side is black. Connect the (+) terminals on both the speaker and the amplifier using the red side of the cable. Connect the (-) terminals on both components using the black side. Red: positive (+) Black: negative (-) Before connecting Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. Red Black Rear speakers Rear center speaker (for NS-P436) Use the provided speaker cables (15 m). One side of the speaker cable has a gray line and the other side has no line. Connect the (+) terminals on both the speaker and the amplifier using the side with a gray line. Connect the (-) terminals on both components using the side with no line. How to Connect: 1 Press and hold the terminal's tab, as shown in the figure. 2 Insert the bare wire. 3 Release your finger from the tab to allow it to lock securely on the cable's wire end. 4 Test the firmness of the connection by pulling lightly on the cable at the terminal. Note Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them. Red: positive (+) Black: negative (-) Gray line E-9