Yamaha NX-E300 Owner's Manual - Page 3
Removing The Front Cover - speakers
View all Yamaha NX-E300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Loosen Black (-) Tighten Red (+) Red line Speaker (R) Red line Speaker (L) Black line Speaker output terminals of the receiver When using a banana plug 3 Banana plug 1 2 1 Remove the cover by pulling it toward you. 2 Tighten the terminal knob. 3 Simply insert the banana plug into the terminal. REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four point and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inner surface of the cover with the four corresponding holes on the speaker and push gently. CRX-E300 How to connect: 1 Loosen the knob. 2 Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. 3 Insert the bare wire. 4 Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the cable at the terminal. Note Do not let the bare speaker wires touch each other as this could damage the speaker or the receiver, or both of them. Note When the cover is removed, be sure not to touch the speaker units with your hands or to exert excessive force with tools. SPECIFICATIONS Type 2-way bass-reflex speaker system Magnetic shielding type Driver 11 cm (4-1/2") cone woofer 2.5 cm (1") dome tweeter Impedance 6 Ω Frequency Response 60 Hz to 28 kHz Nominal Input Power 40 W Maximum Input Power 110 W Sensitivity 85 dB/2.83 V/m Crossover Frequency 3 kHz Dimensions (W x H x D 165 x 255 x 183 mm (6-1/2" x 10" x 7-3/16") Weight 3.4 kg (7 lbs. 8 oz.) x 2 Accessories Speaker cable (4 m) x 2 * Specifications are subject to change without notice due to product improvements. * Care should be taken not to exceed the input power values noted above. 3