Yamaha PM10 RIVAGE PM10 System Setup Guide [English] - Page 29
Rear panel, LAMP jacks, MIDI OUT/IN jacks, GPI connector, FAN] switch, VIDEO OUT connector
View all Yamaha PM10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Rear panel CS-R10 ! # " CS-R10-S ? ! # " ? LAMP jacks These four 4-pin female XLR output connectors are used to supply power to Yamaha LA1L gooseneck lamps supplied with the unit. (CS-R10: 4 jacks; CS-R10-S: 3 jacks) MIDI OUT/IN jacks These connectors are used to transmit and receive MIDI messages to/from external MIDI devices. GPI connector This is a D-sub 25-pin female connector that allows communication (8-in, 8-out) with a GPI-equipped external device. [FAN] switch Sets the internal cooling fan to operate at either HIGH or LOW speed. NOTE This switch is set to LOW when the unit is initially shipped from the factory. As long as the unit is operated within the specified ambient temperature range either the LOW or HIGH setting can be used. The HIGH setting is recommended if the ambient temperature is high, if the unit is in direct sunlight even if the ambient temperature is within the specified operating range, and in any situation in which fan noise is not a problem. VIDEO OUT connector Connect your external display monitor to this DVI-D (Dual-link) connector. [RESET] switch Resets the control surface. Only the controls (screens, indicators, and control keys and knobs) on the control surface will restart without interrupting audio. Use this switch in case the control surface becomes non-responsive to your operations. RIVAGE PM10 System Setup Guide 29