Yamaha RS100 Owner's Manual - Page 6
Attach the Module Holder, Attach the Tom Holders, Attach the Cymbal Holders - manual
View all Yamaha RS100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
I RS100 Assembly * A screw driver (+ or -) is necessary to complete the assembly. Please make sure that the fixing bolts on each part, such as clamps, pads, etc. are firmly tightened. Bolts that are too tight or too loose may result in damage to the part or the part dropping. Please use caution. 1 Attach the Center Pipe Assembly A D and the Center Pipe Assembly B E to the upright pipes of the Side Assembly A A and Side Assembly B B . 2 Attach the Side Arm F to the pipes of the side Assembly B B and the Side Assembly C C . Center Pipe Assembly A D Tighten 3 Attach the Module Holder H 3-1 Attach the Module Holder Clamp I to the pipe of the Side As sembly C C . 3-2 Insert the Tom Holder G into the Module Holder Clamp I , and tighten the fixing screw. 3-3 Attach the DTXTREME to the Module Holder H . Using a screw driver and the supplied screws, attach the Module Holder H to the screw holes on the bottom of the DTXTREME. 3-4 Attach the Module Holder H , with the DTXTREME attached, to the Tom Holder G . DTXTREME Center Pipe Assembly B E Side Assembly B B Side Assembly A A Module Holder H Side Arm F Step 3-3 Side Assembly C C Step 3-4 Tom Holder G Step 3-2 Module Holder Clamp I Step 3-1 4 Attach the Tom Holders G 5 Attach the Cymbal Holders J 4-1 Insert the Tom Holders G into the Holder Clamps, align and tighten the fixing screws. 4-2 Check the position and attach the Real Head Pad, etc. to the Tom Holder G . Align the pads and secure. (Refer to the Real Head Pad's Owner's Manual on how to attach the pads.) Cymbal Holder J Step 4-2 5-1 Insert the Cymbal Attachments into the upright pipes of the Side Assembly A A and Side Assembly B B , and tighten the wing bolts. 5-2 Attach the Cymbal Pad to the Cymbal Holder J , align the pad and secure. Also, when the PCY10 is used, please use the parts shown in the diagram below. (Refer to the Cymbal Pad's Owner's Manual on how to attach the Cymbal Pad.) Cymbal Holder J Step 5-2 Step 5-1 Step 4-2 Step 4-1 Tom Holder G Tom Holder G Step 4-1 Tom Holder G Step 4-1 Cymbal Pad G When the PCY10 is used. Washer* Felt (Small)* PCY10 Felt (Large)* Anti-swivel brace (supplied with the PCY80/80S) Change to the felt washer L . After the above assembly is complete, set the Kick Pad, Hi-Hat Control pedal, etc. into position and connect the necessary cables. To keep cable out of the way while playing, use the supplied Cable Bands K to hold the cables to the rack system's pipes. Cymbal Pad Tilter * The * indicates parts supplied with the PCY10. * It is not necessary to use the tilter that is supplied with the PCY10.