Yamaha RS7000 Owner's Manual - Page 19

The Rear Panel, MIDI IN, OUT A, and OUT B Connectors - scsi

Page 19 highlights

The Controls & Connectors T [PAD 1] and [PAD 2] Velocity-sensitive pads for performance data entry. Tapping these pads enters the pre-specified note data at the specified pitch. The pitch for each pad can be set by playing the appropriate key on the keyboard while holding the [TAP] button and [PAD 1] or [PAD 2]. U CARD Slot Slot for memory card insertion. The Rear Panel 1 4 56 7 8 9 MUSICAL INSTRUMENT 379U US LISTED MIDI POWER CAUTION ON/ OFF RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ÉLECTRIQUE NE PAS OUVRIR. WARNING TO REDUCETHE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. AC INLET MODEL SER. NO. MADE IN JAPAN THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003. CET APPAREIL NUMÉRIQUE DE LA CLASSE B EST CONFORME À LA NORME NMB-003 DU CANADA. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLWWING TWO CONDITIONS: (1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,AND (2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECIVED,INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. IN INPUT OUTPUT SCSI FOOT SW CONTRAST R L R L/MONO PHONES OUT A OUT B 2 3 1 POWER Switch Press in to turn the RS7000 on, and press again to turn it off. 2 AC INLET The AC power cable supplied with the RS7000 is plugged in here. Use only the supplied cable. 3 MIDI IN, OUT A, and OUT B Connectors If you plan to use a MIDI keyboard or other instrument to play and program the RS7000, it should be connected to the MIDI IN connector. The MIDI OUT A and B connectors can be connected to an external tone generator or synthesizer if you want to transmit performance data, button and knob operations, and pad operations to external equipment from the RS7000. 4 SCSI Connector External SCSI storage devices (hard disks, CD-ROM drives, etc.) can be connected here. The connector is a 50pin half-pitch type. 5 FOOT SW Jack An optional Yamaha FC4 or FC5 footswitch connected to this jack can be used for start/stop, section selection, sustain, or tap BPM entry. 6 CONTRAST Control Use the CONTRAST control to achieve the best LCD display visibility (LCD visibility varies with viewing angle). 7 INPUT L and R Jacks Analog mono or stereo signals can be connected here for sampling (recording). Connect mono signals to either the L or R jack. 8 OUTPUT L/MONO & R Jacks These are the main stereo outputs from the RS7000. When a plug is inserted into only the L/MONO output, the left- and right-channels signals are mixed and delivered via that output to allow direct connection to mono sound systems. 9 PHONES Jack Any pair of stereo headphones with a 1/4" stereo phone plug can be plugged in here for convenient monitoring. The PHONES output level is adjusted via the MASTER VOLUME control. RS7000 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331
  • 332
  • 333
  • 334
  • 335
  • 336
  • 337
  • 338
  • 339
  • 340
  • 341
  • 342
  • 343
  • 344
  • 345
  • 346
  • 347
  • 348
  • 349
  • 350
  • 351
  • 352

The Controls & Connectors
RS7000
19
T
[PAD 1] and [PAD 2]
Velocity-sensitive pads for performance data entry. Tapping
these pads enters the pre-specified note data at the speci-
fied pitch. The pitch for each pad can be set by playing the
appropriate key on the keyboard while holding the [TAP]
button and [PAD 1] or [PAD 2].
U
CARD Slot
Slot for memory card insertion.
The Rear Panel
1
POWER Switch
Press in to turn the RS7000 on, and press again to turn it
off.
2
AC INLET
The AC power cable supplied with the RS7000 is plugged
in here. Use only the supplied cable.
3
MIDI IN, OUT A, and OUT B Connectors
If you plan to use a MIDI keyboard or other instrument to
play and program the RS7000, it should be connected to
the MIDI IN connector.
The MIDI OUT A and B connectors can be connected to an
external tone generator or synthesizer if you want to trans-
mit performance data, button and knob operations, and pad
operations to external equipment from the RS7000.
4
SCSI Connector
External SCSI storage devices (hard disks, CD-ROM
drives, etc.) can be connected here. The connector is a 50-
pin half-pitch type.
5
FOOT SW Jack
An optional Yamaha FC4 or FC5 footswitch connected to
this jack can be used for start/stop, section selection, sus-
tain, or tap BPM entry.
6
CONTRAST Control
Use the CONTRAST control to achieve the best LCD dis-
play visibility (LCD visibility varies with viewing angle).
7
INPUT L and R Jacks
Analog mono or stereo signals can be connected here for
sampling (recording). Connect mono signals to either the L
or R jack.
8
OUTPUT L/MONO & R Jacks
These are the main stereo outputs from the RS7000. When
a plug is inserted into only the L/MONO output, the left- and
right-channels signals are mixed and delivered via that out-
put to allow direct connection to mono sound systems.
9
PHONES Jack
Any pair of stereo headphones with a 1/4” stereo phone
plug can be plugged in here for convenient monitoring. The
PHONES output level is adjusted via the MASTER VOL-
UME control.
POWER
MIDI
IN
SCSI
THIS CLASS B DIGITAL APPARATUS COMPLIES WITH CANADIAN ICES-003.
MUSICAL INSTRUMENT
US LISTED
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ATTENTION
: RISQUE DE CHOC
É
LECTRIQUE NE PAS OUVRIR.
WARNING
379U
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLWWING TWO CONDITIONS:
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,AND
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECIVED,INCLUDING INTERFERENCE
THAT MAY CAUSE UNDESIRED OPERATION.
CET APPAREIL NUM
É
RIQUE DE LA CLASSE B EST CONFORME
À
LA NORME NMB-003
DU CANADA.
FOOT
SW
CONTRAST
R
R
INPUT
OUTPUT
L
L/MONO
PHONES
OUT
A
OUT
B
MODEL
SER. NO.
MADE IN JAPAN
ON
/
AC
INLET
OFF
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSETHIS PRODUCTTO RAIN OR MOISTURE.
1
2
3
4
5
6
7
8
9