Yamaha RX-395 Owner's Manual - Page 14
Basic Operations, To Play A Source
View all Yamaha RX-395 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
BASIC OPERATIONS 2 3 1, 6 4 TO PLAY A SOURCE 1 Set to the " ∞ " position. 2 Turn the power on. POWER 7 4 Select the speakers to be used. SPEAKERS A B ON ON OFF OFF * If you use two speaker systems, press both the A and B switches. 5 Play the source. (For detailed information on the tuning operation, refer to page 17.) 6 3 Select the desired input source by using the input selector buttons. RX-495 TUNER CD MONITOR TAPE 2 TAPE 1 AUX PHONO COPY RX-395 TUNER CD TAPE MONITOR AUX PHONO * The name of the selected input source will appear on the display. * Note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel. 14 Adjust to the desired output level. 7 If desired, adjust the BASS, TREBLE, BALANCE and LOUDNESS controls, etc. (refer to page 16). Notes RX-495 only q If you select AUX, TUNER, CD or PHONO, be sure that TAPE 1 and/or TAPE 2 are not being selected. q If you select TAPE 1 and TAPE 2 at the same time, the result will be the sound from the tape deck 1. q For TAPE 1 and TAPE 2, whenever the button is pressed, the corresponding input source is selected or canceled alternately. RX-395 only q Whenever the TAPE MONITOR is pressed, the tape deck is selected or canceled alternately. q If both TAPE MONITOR and another input selector button are selected, TAPE MONITOR takes priority of another input selector button. To turn off the power Press the POWER switch again.