Yamaha RX-A3080 RX-A3080/RX-A2080 Owner s Manual - Page 65

Error messages If any error message is displayed during the measurement, resolve the problem and perform YPAO again. Error message Remedy ERROR 1 Front speakers are not detected. ERROR 2 One of the surround speakers cannot be detected. ERROR 3 One of the front presence speakers cannot be detected. Follow the on-screen instructions to exit YPAO, turn off the unit, and then check the speaker connections. ERROR 4 One of the surround back speakers cannot be detected. ERROR 5 The noise is too loud. Keep the room quiet and follow the on-screen instructions to start the measurement again. If you select "Proceed", YPAO takes the measurement again and ignores any noise detected. ERROR 6 Surround back speakers are connected, but no surround speakers are connected. Surround speakers need to be connected in order to use surround back speakers. Follow the on-screen instructions to exit YPAO, turn off the unit, and then reconnect the speakers. ERROR 7 The YPAO microphone has been removed. Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the measurement again. ERROR 8 The YPAO microphone cannot detect test tones. Connect the YPAO microphone to the YPAO MIC jack firmly and follow the on-screen instructions to start the measurement again. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. ERROR 9 Canceled by user operation Follow the on-screen instructions to start the measurement again. To cancel the measurement, select "Quit". ERROR 10 Follow the on-screen instructions to exit YPAO, turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha An internal error has occurred. dealer or service center. ERROR 11 One of the rear presence speakers cannot be detected. Follow the on-screen instructions to exit YPAO, turn off the unit, and then check the speaker connections. En 65