Yamaha RX-A6A RX-A6A User Guide - Page 129
Error messages from YPAO, Search tag]#Q03 YPAO Error
View all Yamaha RX-A6A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
PREPARATIONS > Configuring the speaker settings Error messages from YPAO If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO again. [Search tag]#Q03 YPAO Error Error message Remedy ERROR 1 Front speakers are not detected. ERROR 2 One of the surround speakers cannot be detected. ERROR 3 Exit YPAO, turn off the unit, and then check the speaker connections. One of the front presence speakers cannot be detected. ERROR 4 One of the surround back speakers cannot be detected. ERROR 5 The noise is too loud. Keep the room quiet and retry YPAO. If you select "Proceed", YPAO takes the measurement again and ignores any noise detected. ERROR 6 Surround back speakers are connected, but no surround speakers are connected. Surround speakers need to be connected in order to use surround back speakers. Exit YPAO, turn off the unit, and then reconnect the speakers. ERROR 7 The YPAO microphone has been removed. Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. ERROR 8 The YPAO microphone cannot detect test tones. Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. ERROR 9 Canceled by user operation Retry or exit YPAO as necessary. ERROR 10 An internal error has occurred. Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. ERROR 11 One of the rear presence speakers Exit YPAO, turn off the unit, and then check the speaker connections. cannot be detected. NOTE ( To exit the YPAO measurement for resolving the problem, select "Quit". ( For the ERROR 5 and ERROR 9 messages only, you can proceed with the current YPAO measurement. Select "Proceed". ( To retry the YPAO measurement from beginning, select "Retry". 129