Yamaha RX-N600 Owner's Manual - Page 44
USING VIDEO FEATURES, Displaying the input source information, Displaying the input source - remote controller manual
View all Yamaha RX-N600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
USING VIDEO FEATURES USING VIDEO FEATURES Displaying the input source information You can display the format, sampling frequency, channel, bit rate and flag data of the current input signal. 1 Set the component selector switch to AMP and then press SET MENU on the remote control. The top "SET MENU" display appears in the OSD. AMP SOURCE TV SET MENU MENU SRCH MODE SET MENU . ;BASIC SETUP ;MANUAL SETUP . ;SIGNAL INFO [ ]/[ ]:Up/Down [ENTER]:Enter p p 2 Press d repeatedly to select "SIGNAL INFO" and then press ENTER. The following information about the input source appears in the OSD. PRESET/CH PRESET/CH A-E/CAT. ENTER A-E/CAT. A-E/CAT. ENTER A-E/CAT. ;SIGNAL INFO FORMAT PCM SAMPLING 48kHz CHANNEL 2/0/--- BITRATE --- FLAG NONE [RETURN]:Exit Signal format FORMAT Signal format display. When this unit cannot detect a digital signal, it automatically switches to analog input. Display status: Analog, Digital, DolbyD, DTS, MP3, PCM, WMA, --- Note "---" appears when this unit cannot detect any signals. Sampling frequency SAMPLING The number of samples per second taken from a continuous signal to make a discrete signal. Display status: 8kHz, 11kHz, 12kHz, 16kHz, 22.05kHz, 24kHz, 32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz, 96kHz, --- Note "---" appears when this unit cannot detect the sampling frequency. Channel CHANNEL The number of source channels in the input signal (front/surround/LFE). For example, a multi-channel soundtrack with 3 front channels, 2 surround channels and LFE, is displayed as "3/2/0.1". Note "---" appears when there is no source channel available. Bit rate BITRATE The number of bits passing a given point per second. Note "---" appears when this unit cannot detect the bit rate. Flag FLAG Flag data encoded in DTS, Dolby Digital, or PCM signals that cue this unit to automatically switch decoders. 3 Press SET MENU on the remote control again to exit from "SET MENU". SET MENU MENU SRCH MODE 40 En