Yamaha RX-V357 Owner's Manual - Page 46

SET MENU SOUND 5 CENTER GEQ (center graphic equalizer) INPUT 1 I/O ASSIGN (input/ output assignment) Use this feature to adjust the built-in 5-band graphic equalizer so that the center speaker tonal quality matches that of the left and right front speakers. You can select the 100 Hz, 300 Hz, 1 kHz, 3 kHz, or 10 kHz frequencies. Control range (dB): -6 to +6 Initial setting: 0 dB for 5-band 1 Press d to select a higher frequency and u to select a lower frequency. 2 Press -/+ to adjust the level of that frequency. Note • You can monitor the center speaker sound while adjusting this parameter by using the test tone. Press TEST before starting the foregoing procedure. Once you begin this procedure, the test tone remains at the center speaker and you can hear how the sound changes as you adjust the various frequency levels. To stop the test tone, press TEST. SOUND 6 HP TONE CTRL (headphone tone control) Use this feature to adjust the level of the bass and treble when you are using headphones. Control range (dB): HP BASS 6 to +3 HP TRBL (treble) ....... -6 to +3 Initial setting: HP BASS 0 dB HP TRBL 0 dB You can assign jacks according to the component to be used if this unit's initial settings do not correspond to your needs. Change the following parameters to reassign the respective jacks and effectively connect more components. Once the inputs have been reassigned, you can select the corresponding component by using INPUT l / h on the front panel or the input selector buttons on the remote control. For COMPONENT VIDEO jacks A (1A[A]) and B (1A[B]) Choices: [A] VCR, V-AUX, DTV/CBL, DVD [B] VCR, V-AUX, DTV/CBL, DVD For OPTICAL INPUT jacks 1 (1B(1)) and 2 (1B(2)) Choices: (1) VCR, V-AUX, DTV/CBL, DVD, MD/CD-R, CD (2) VCR, V-AUX, DTV/CBL, DVD, MD/CD-R, CD For COAXIAL INPUT jack 3 (1C(3)) Choices: VCR, V-AUX, DTV/CBL, DVD, MD/CD-R, CD Notes • You cannot select a specific item more than once for the same type of jack. • When you connect a component to both the COAXIAL and OPTICAL jacks, priority is given to the input signals from the COAXIAL jack. INPUT 2 INPUT MODE (initial input mode) Use this feature to designate the input mode for sources connected to the DIGITAL INPUT jacks when you turn on this unit (see page 24 for details about the input mode). Choices: AUTO, LAST AUTO Select this setting to allow the unit to automatically detect the type of input signal and select the appropriate input mode. LAST Select this setting to set this unit to automatically select the last input mode used for the respective sources. 44