Yamaha RX-V6A RX-V6A User Guide - Page 99

PREPARATIONS > Configuring the speaker settings Error messages from YPAO If any error message is displayed, resolve the problem by following on-screen instructions and perform YPAO again. [Search tag]#Q03 YPAO Error Error message E-1:No Front SP E-2:No Sur. SP E-3:No F.PRNS SP E-4:No Sur. Back SP E-5:Noisy E-6:Check Sur. E-7:No MIC E-8:No Signal E-9:User Cancel E-10:Internal Err. Remedy Exit YPAO, turn off the unit, and then check the speaker connections. Keep the room quiet and retry YPAO. If you select "PROCEED", YPAO takes the measurement again and ignores any noise detected. Surround speakers need to be connected in order to use surround back speakers. Exit YPAO, turn off the unit, and then reconnect the speakers. Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. Connect the YPAO microphone to the YPAO jack firmly and retry YPAO. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. Retry or exit YPAO as necessary. Exit YPAO, and turn off and on the unit. If this error occurs repeatedly, contact the nearest authorized Yamaha dealer or service center. NOTE ( To exit the YPAO measurement for resolving the problem, press ENTER, and select "EXIT". ( For the E-5 and E-9 messages only, you can proceed with the YPAO measurement. Press ENTER, and select "PROCEED". ( To retry the YPAO measurement from beginning, press ENTER, and select "RETRY". 99