Yamaha RX-V890 Owner's Manual - Page 36

To clear a learned function 1 Set to the "USER" position. USER YPC LEARN 2 Press and hold the CLEAR button using the point of a mechanical pencil, etc. To clear all learned functions 1 Set to the "LEARN" position. USER YPC LEARN 2 Press and hold the CLEAR button using the point of a mechanical pencil, etc. CLEAR 3 Press and hold the key where the learned function to be deleted is until the indicator flashes 3 times. TRANSMIT /LEARN • To clear two or more functions, repeat step 2 and 3. Note: If a key is not pressed soon after the CLEAR button is pressed, this unit will automatically return to the status that was in effect before the CLEAR button was pressed. CLEAR 3 Press and hold any key until the indicator flashes 7 times TRANSMIT /LEARN Troubleshooting guide SYMPTOM The remote control transmitter does not work. Learning cannot be made successfully. (The TRANSMIT/LEARN indicator does not light up or flash.) CAUSE The batteries of this remote control transmitter are weak. The internal microcomputer "freezes". The batteries of this remote control transmitter and/or the other remote control transmitter are weak. The distance between the two remote control transmitters is too long or too short. The signal coding or modulation of the other remote control transmitter is not compatible with this remote control transmitter. Memory capacity is full. REMEDY Replace the batteries with new ones and press the RESET button on the remote control transmitter. Replace the batteries (and press the RESET button for this remote control transmitter). Place the remote control transmitters with the proper distance. Learning is not possible. Further learning is not possible without deleting unnecessary commands. Press the RESET button on the remote control transmitter. 36