Yamaha Ro8-D Ri8-D/Ro8-D Owners Manual [English] - Page 16
Head Amp Control
View all Yamaha Ro8-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Head Amp Control Head Amp Control The Ri8-D head amplifiers can be remotely controlled from a host device, such as a compatible Yamaha digital mixing console. Control from an Ri8-D-native Device The Ri8-D head amplifiers can be controlled remotely from an Ri8-D-native digital mixing console, such as a CL series product. The connected Ri8-D-native device displays the model name and UNIT ID number of the corresponding Ri8-D unit to be controlled. If you plan to connect a device that features Ri8-D-native support to monitor and control the head amplifiers, refer to the owner's manual for the corresponding device. Control from a Device That Does Not Feature Ri8-D-Native Support This section explains how to configure the Ri8-D settings that are required to control the Ri8-D as AD8HR units from a device that does not feature Ri8-D-native support. For more information, please refer to the "Dante-MY 16-AUD & R Series HA Remote Control Guide" that is downloadable from the website listed below. http://www.yamahaproaudio.com/ NOTE The following Yamaha non-Ri8-D-native devices enable you to control the Ri8-D as AD8HRs. Insert the Dante-MY16-AUD card which is a firmware controllable as AD8HR into the Mini-YGDAI slot for connection. M7CL, LS9, DM1000, DM2000, PM5D/DSP5D, DME64N/24N Setting the DIP Switches While the power to the unit is off, flip DIP switch 5 down and DIP switch 6 up. Setting the UNIT ID Setting the Ri8-D in [AD8HR] will set UNIT ID as virtual ID (as AD8HR Device ID). If you combine Rio3224-D or Rio1608-D or add an AD8HR or SB168-ES in the network, make sure that the IDs are all unique. Set the Ri8-D correctly so that you can control it as AD8HRs. In addition, scene recall can be used to recall all head amplifier settings at once. Refer to the digital mixing console owner's manual for details on head amplifier control. Head Amplifier Parameters That Can be Monitored and Controlled Parameter Description +48V Turns +48V phantom power ON or OFF for each channel. HA GAIN Adjusts gain from -6 dB to 66 dB in 1-dB increments. HPF Turns the high-pass filter ON or OFF. HPF FREQ Adjusts the cutoff frequency of the high-pass filter (12 dB/Oct.) from 20 Hz to 600 Hz in 60 steps. METER Displays a level meter for each (Ri8-D-native device only) input channel. Device ID It displays Device ID 1-F (Device ID as AD8HR) assigned based on the UNIT ID. +48V Master SW Displays the [+48V MASTER] switch ON/OFF status of the +48V phantom power supply. Gain Compensation Turns the Gain Compensation ON (Ri8-D-native device only) or OFF. 56 NOTE If REMOTE has been set to [AD8HR], START UP MODE will be set to [RESUME] regardless of the DIP switch setting. 16 Owner's Manual