Yamaha S659 Owner's Manual - Page 42

Troubleshooting Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, set this unit to the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center. Problem No power No picture No picture is displayed when you make HDMI connections (using the HDMI jacks) No picture is displayed when you do not use progressive scan connections (using the component video jacks) Completely distorted picture or black/white picture or no picture Distorted picture The screen size looks unnatural, or the caption is displayed only partially on the TV monitor or is not displayed at all No sound or distorted sound Solution - Connect the AC power cord properly. - Press STANDBY/ON on the front panel to turn on the power. - Refer to the manual supplied with your TV for correct Video In channel selection. Change the TV channel until you see the DVD screen. - Turn on your TV. - Check the video connection. - Follow the steps below to change the [HDMI VIDEO] to [AUTO]; 1. Press OPEN/CLOSE (/) on the front panel or press and hold STOP (9) on the remote control to open the disc tray. 2. Press 1 on the remote control. 3. Press ANGLE on the remote control. - Follow the steps below to turn off the progressive scan; 1. Press OPEN/CLOSE (/) on the front panel or press and hold STOP (9) on the remote control to open the disc tray. 2. Press 1 on the remote control. 3. Press MUTE on the remote control to deactivate progressive scan. This unit is set to Component/Interlaced video. - Check that the disc is compatible with this unit (see "Notes about discs/content format" on page 3). - Check that the TV Type of this unit is set to match that of the disc and your TV (see "Setting a color system for your TV" on page 11). Follow the steps below to change the setting of [TV TYPE]. 1. Press OPEN/CLOSE (/) on the front panel or press and hold STOP (9) on the remote control to open the disc tray. 2. Press 2 on the remote control. 3. Press AUDIO on the remote control. - Occasionally, a small amount of picture distortion may appear depending on the disc being played back. This is not a malfunction. - Check that the TV setting of this unit matches the screen size of your TV (see "Setting the TV display" on page 27). - Change the screen size and the aspect ratio of your TV. - Adjust the volume. - Check that the speakers are connected correctly. - For MP3/WMA files, check that the sampling rate and bit rate are compatible with this unit (see "Notes about discs/content format" on page 3). 38 En