Yamaha Soavo-900C Owner's Manual - Page 3

English CONNECTION TO YOUR AMPLIFIER Before making connection, make sure that the amplifier is switched off. • Connect the screw-type terminals at the rear of the speaker to the speaker terminals of the amplifier with the speaker cable (sold separately). • Connect the (+) terminals on the amplifier and the speaker using one side of the cable. Connect the (-) terminals on both components using the other side of the cable. • Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, -). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass. How to connect: 1 Loosen the knob. 2 Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. Good No Good 10 mm (3/8") 3 Insert the bare wire in to the hole. 4 Tighten the knob and secure the cable. Test the firmness of the connection by pulling lightly on the cable at the terminal. Notes • Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier, or both of them. • Do not insert the insulation coating into the hole. The sound may not be produced. Loosen Black (-) Bare wire Tighten Red (+) Insulation coating Soavo-900C CENTER + - Amplifier When using a banana plug 1 Unscrew the terminal knob. 2 Remove the cover by pulling it toward you. 2 1 3 Tighten the terminal knob. 4 Simply insert the banana plug into the terminal. 4 3 Banana plug 3En