Yamaha Soavo-900SW Owner's Manual - Page 19
Operating the power of this unit using the remote control of your amplifier, Setting, Canceling
View all Yamaha Soavo-900SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Operating the power of this unit using the remote control of your amplifier * This function is available only for Yamaha amplifiers that meet the following conditions: - The amplifier was released in 2005 or later. - The remote control of the amplifier has two different buttons for STANDBY and ON. Note When the AMP ID library code of the remote control has been changed, this function may not work. USING THIS UNIT ■ Canceling 1 Set POWER switch on the rear panel to the OFF position. 2 Set POWER switch to the ON position while pressing and holding STANDBY/ON switch on the front panel. Continue holding down STANDBY/ON switch for 3 seconds or longer. Rear panel POWER ON OFF POWER switch Front panel SUBWOOFER SYSTEM Soavo-900SW 1 2 31 2 3 STANDBY /ON PHASE B.A.S.S. PRESET STANDBY /ON 0 40Hz 100Hz H-CUT 10 VOLUME STANDBY/ON switch ■ Setting 1 Set POWER switch on the rear panel to the OFF position. 2 Set POWER switch to the ON position while pressing and holding STANDBY/ON switch on the front panel. Continue holding down STANDBY/ON switch for 3 seconds or longer. After the STANDBY/ON indicator flashes 2 times, the setting is completed. SUBW STANDBY /ON Note Place this unit within the operating range of the remote control of the amplifier. If you place this unit far away from the amplifier, you may not be able to operate this unit with the remote control. After the STANDBY/ON indicator flashes 4 times, the setting is completed. SUBW STANDBY /ON 15 En