Yamaha TSS-15 Owner's Manual - Page 15
Adjusting Speaker Levels with the Test Tone - reset
View all Yamaha TSS-15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
English Adjusting Speaker Levels with the Test Tone It's important that all speakers can be heard equally at the listening position. The TSS-15 has a built-in test tone for adjusting the level of each speaker. Notes: • The test tone cannot be used while a pair of headphones is connected. • The Night listening mode cannot be used while the test tone is being output. • The test tone can be used with the Virtual Surround function (see page 16). 3 Press the [TEST] button. The test tone is output by each speaker for 2.5 seconds in the following order: front left, center, front right, surround right, surround left, subwoofer. The TSS-15's CINEMA DSP buttons indicate which speaker is currently outputting the test tone, as shown below. MOVIE MUSIC SPORTS GAME MODE STANDBY/ON STANDBY/ON [ ] MOVIE MUSIC SPORTS GAME VOLUME MUTE VOLUME +/- SP LEVEL NIGHT SW CENTER SURR TEST DUAL MONO TEST 1 2 3 4 INPUT MOVIE MUSIC SPORTS GAME MOVIE MUSIC SPORTS GAME Front left speaker Subwoofer MOVIE MUSIC SPORTS GAME Center speaker Front right speaker Listening position Surround left speaker MOVIE MUSIC SPORTS GAME Surround right speaker MOVIE MUSIC SPORTS GAME TSS-15 WD76700 This procedure should be performed from the listening position. 1 To turn on the TSS-15, press the [STANDBY/ON] button. The STANDBY/ON button on the TSS-15 lights up. 2 Set the volume to about 4. Note: If the test tone is too quiet, turn up the TSS-15 amplifier's VOLUME control. If it's too loud, turn it down. 4 While the test tone is being output by a speaker, use the VOLUME Up [+] and Down [-] buttons to adjust its level. While the level is being adjusted, the test tone will continue to be output by the same speaker. When you stop adjusting the level, the test tone will be output by the next speaker in the order stated above. Notes: • The level of each speaker is shown by the volume level indicators on the TSS-15 (-6, -4, -2, 0, +2, +4, +6). • The front left and right speaker levels cannot be set above 0. • To reset all speakers to their default levels, while the test tone is being output, press the TSS-15 amplifier's [MODE] button for two seconds. 5 When you've finished adjusting the level of each speaker, press the [TEST] button again to turn off the test tone. 13