Yamaha TSX-W80 Owner's Manual - Page 15

English SPECIFICATIONS Remote control Problem Cause Solution The remote control does not The remote control may be operated work properly. outside its operation range. For information on the remote control operation range, refer to "Using the remote control" (☞ P. 1). The remote control sensor on the unit may be exposed to direct sunlight or lighting (inverted fluorescent lamps). Change the lighting or orientation of the unit. The battery may be worn out. Replace the battery with a new one (☞ P. 1). There are obstacles between the sensor of Remove the obstacles. the unit and the remote control. Wireless communication is not established when SOURCE is set to iPod. Play the iPod to establish wireless communication (☞ P. 6). SPECIFICATIONS ■ PLAYER SECTION iPod • Supported iPod .....iPod (5th generation), iPod classic, iPod nano, iPod touch, iPhone, iPhone 3G, iPhone 3GS AUX IN • Input connector ............STEREO L/R: 3.5 mm (1/8 in) STEREO mini Jack ■ AMPLIFIER SECTION • Maximum output power 4 W + 4 W + 8 W (6 Ω 1 kHz, 10% THD) • Driver unit 4 cm (1 5/8 in) full-range driver × 2 5.5 cm (2 1/8 in) woofer + SR-BASS × 1 ■ TUNER SECTION • Tuning range FM 87.50 to 107.90 MHz AM 530 to 1710 kHz ■ TRANSMITTER SECTION • Frequency 2.4 GHz • Transmission range Approx. 20 m (65.6 ft) (without interference) • Number of units which can be simultaneously transmitted to Up to 7 units (depending on the circumstances) ■ GENERAL • Power Supply AC 120 V, 60 Hz • Power consumption 10 W • System off consumption 3.5 W • Standby consumption 1.0 W or less • Dimensions (W × H × D 260 × 90.3 × 141 mm (10 1/4 × 3 1/2 × 5 1/2 in) • Weight 1.2 kg (2.6 lbs.) Specifications are subject to change without notice. iPod™, iPhone™ iPod is a trademark of Apple Inc., registered in the U.S. and other countries. iPhone is a trademark of Apple Inc. "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. "Works with iPhone" means that an electronic accessory has been designed to connect specifically to iPhone and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. 11 En