Yamaha UD-USB01 Owner's Manual - Page 2
方法, :同时将本机和, 软盘驱动器安装到, :仅将本机安装到
View all Yamaha UD-USB01 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Method 1: Installing only this unit to the Electone ٚ م1 Electone 1 Insert but do not fully tighten one of the screws to the right front screw hole under the Electone MFDUPOF b 2 Hook this unit (with hole A, shown below) onto the installed screw b 6 Method 2: Installing both this unit and the UD-FD01 floppy disk drive to the Electone ٚ م2 UD-FD01 Electone None of the included screws are necessary in this method. Both this unit and the floppy disk drive are installed by using the screws for the floppy disk drive b b 1 Remove the floppy disk drive from the Electone (if the floppy disk drive has already been installed.) The floppy disk drive can be removed by reversing the order of the installation instructions described in the Owner's Manual of the Electone. Ֆ Electone bοᅶ Electone b A 3 Insert and partially fix the remaining three screws. Then, firmly tighten all four screws. b b 4 64 64#50%&7 Connect the USB cable to the USB TO DEVICE terminal. ࡼ 64 64#50%&7*$& ؊१b For Japanese users only 5 64 2 Put this unit on top of the floppy disk drive as shown. Then, align the four holes of these two units. b b 3 Temporarily install these two units together with A screw A. Insert and partially fix the remaining three screws. Then, firmly tighten all four screws. b b b 4 Follow step 4 in Method 1 b 64 Connecting USB storage devices ৵ࢤ 64# թԥഡС 64#50%&7 When connecting a USB storage device to the USB TO DEVICE, make sure that the connector on the device is appropriate and that it is connected in the proper direction. ࡼ USB USB TO DEVICE b While holding this button, pull the unit toward you. b ԋதɺ64 64 During your performance, make sure to slide the USB unit under the keyboard. If you leave it in the forward position, there is a danger of hitting it with your hand and breaking the USB device. USB ֆჭb USB ഡСb JA EN ZH