Yamaha V3.5 DME Designer V3.5 DME Setup Manual - Page 3

1. Installing the Software 2. Basic Setup (via USB cable) 3. Advanced Setup (via Ethernet cables) 4. In-depth information Appendix: Detailed on DME Units DME-N Network Driver Settings 1-2. Install the USB-MIDI Driver 1-2-1 Turn on the DME unit and connect it to your computer using a USB cable. When the message "Installing device driver software" appears in the taskbar at the bottom right of the screen, install the driver manually. 1-2-6 Click the[Install]button. 1-2-2 "Found New Hardware" window appears. Select [Locate and install driver software (recommended)]. 1-2-7 Installing driver software. 1-2-3 Select [I don't have the disc. Show me other options.]. 1-2-4 Select [Browse my computer for driver software (advanced).]. 1-2-5 Click the[Browse]button. Locate the downloaded and extracted "Driver" folder and click [OK].Click [Next] to start the installation process. 1-2-8 A message will appear when installation has finished. Click [Close] to complete the driver installation process. 1-2-9 The procedure and screen which were described here are a case of WindowsVista. When Windows 2000 or Windows XP is used, please set up similarly according to directions of a screen. For the latest information about DME Designer System Requirements, visit the Yamaha Pro Audio website: http://www.yamahaproaudio.com/ Troubleshooting & Tips Precaution regarding USB ports and driver installation On computers featuring multiple USB ports, drivers are installed individually for each port. After installation, therefore, if connection is made via a port other than that originally used, it will be necessary to install the driver once again. To avoid this, either set a dedicated port for DME connection in advance or install the driver on all of your computer's ports. It is also important to note that USB drivers differ depending on the model of DME used. Although the same driver can be used for multiple DME units of the same model, different models - such as the DME64N and DME24N - require different USB drivers. (To be exact, the USB drivers themselves are identical, but the INF files used upon installation differ.) Avoid USB hubs As is often the case with digital mixers, your computer may not recognize the DME unit if connected via a USB hub. In principle, therefore, connection should be made directly to one of your computer's built-in USB ports. 03