Yamaha YAS-306 YAS-306 Owner s Manual - Page 31

Enabling/disabling the Bluetooth function Enable or disable the Bluetooth function. NOTE • By default, the Bluetooth function is enabled. 1 Turn off the unit. 2 Hold down the key and press the key on the unit. CONNECT The Bluetooth function is enabled, and the unit turns on. For several seconds immediately after the unit is turned on, the indicator shows Bluetooth function status. Off (disabled), glows (enabled) Updating the unit's firmware New firmware that provides additional features or product improvements will be released as needed. Firmware can be updated using the MusicCast CONTROLLER app installed on a mobile device. Cautions • Do not operate the unit or disconnect the power cable or network cable during firmware update. • If the Internet connection speed is slow, or the unit is connected to the wireless network, network update may not be possible depending on the condition of the network connection. Should this occur, try again at a later time. • For details on update, visit the Yamaha website. When a new firmware is released, the "Update new firmware now?" message is displayed on the MusicCast CONTROLLER app's screen. 1 Tap "Yes". The firmware update will begin. A progress bar indicating update progress will be displayed by the app while firmware is updated. Update progress can also be confirmed using the indicators on the unit. Update progress HINT • If there are multiple firmware updates, the indicators will start glowing as each firmware update begins. • If "Later" is selected, tap (Setup) in the app's room selection screen, and then select "New firmware is available". Follow the on-screen instructions to update the firmware. If the update is completed successfully, the "Firmware update completed" message will be displayed by the app, and all indicators on the unit will flash. SETTINGS ➤ Enabling/disabling the Bluetooth function En 31