Yamaha YDP-123 Owner's Manual - Page 29
Keyboard Stand Assembly
View all Yamaha YDP-123 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
ENGLISH Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready 1. Attach the side panels to the pedal box. Side panel (left) (2) Align the sides of the pedal box with the left and right side panels. Remove the following parts from the package. Assembly Parts 6 × 20 mm long screws ×4 1 4 × 20 mm tapping screws ×4 4 6 × 16 mm short screws ×4 2 Cord holders × 2 4 × 12 mm thin screws ×2 3 Main unit Side panel (right) (3) Use the four 6×20 mm long screws 1 to attach the pedal box. (1) Untie and straighten out the bundled cord attached to the bottom of the pedal box. Don't discard the vinyl tie, you'll need it later in step 5. 2. Attach the rear panel. (1) Secure the top of the rear panel to the side panel brackets using two 4×12 mm thin screws 3. L R L Side panel (left) Rear panel Side panel (right) Pedal box Bundled pedal cord inside AC power cord TIP A headphone hanger is included in the YDP-123 package. You can attach a headphone hanger on the YDP-123 to hang the headphones (page 12). (2) Secure the bottom of the rear panel to the pedal box using four 4×20 mm tapping screws 4. YDP-123 Keyboard Stand Assembly 29