Yamaha YHT-33 YHT-33 Connection Diagram - Page 10

YHT-33 QUICK-CON N ECT GUIDE PROGRAMMING THE UNIVERSAL REMOTE CONTROL Indicator LED Use Keypad To Enter Setup Codes Component Selector Buttons Turns On Component's Power SETTING UP COMPONENTS Perform the procedure for each component you own. At the end of each step 5, the remote control's processor will automatically assign the selected component's control functions to its own buttons, ready for your use. SETTING UP YOUR TV 1. Turn on the television set and look up a setup code for your brand of television (codes are located at the back of the HTR-5240 Owner's Manual). 2. On the remote control, press TV. Use To Enter Setup Mode Use To Enter Setup Mode 3. Press and hold both VOLUME buttons at least four seconds until the indicator LED flashes twice. The YHT-33 Home Theater package includes a universal remote control. It comes pre-programmed with factory codes to control your HTR-5240 receiver and most Yamaha audio components. To program other brands of components (i.e., TV, VCR, etc.) or if your Yamaha unit does not respond, you will need to program the remote control with the manufacturer's codes (listed on the back pages of the HTR-5240 Owner's Manual). NOTE: The universal remote control is designed to control most major brands of audio and video components. For other units, use the original remote control supplied with the product. POWER ON 1. Load the supplied batteries into the remote control. 2. Aim the remote control at the receiver, press AMP/ TUNER, and then press POWER. 3. The receiver should turn on. 4. Using the keypad, enter the four-digit setup code. The indicator LED will flash twice after your entry. If the LED did not flash twice, repeat steps 3 and 4. 5. To verify the code works, aim the remote control at the television set, press TV, and then press POWER. The television set should turn off. If it doesn't respond, use another code for the same manufacturer and repeat steps 3 through 5. 10