Yamaha YHT-500 Quick Connection Guide - Page 6

YHT-500 QU I C K -CONNECT GUIDE CONNECTING THE YAMAHA DV-S5450 DVD PLAYER Yamaha HTR-5540 Receiver (Rear Panel) DIGITAL INPUT COAXIAL CD MAIN SURROUND 6CH INPUT AUDIO R L OPTICAL DVD SUB WOOFER CENTER CD IN (PLAY) MD /CD-R OUT (REC) R L SUB WOOFER AUDIO OUTPUT VIDEO V-AUX IN VCR OUT D-TV /CBL VIDEO TUNER AM ANT GND 75 UNBAL. FM ANT DVD MONITOR OUT VIDEO SPEAKERS R MAIN L R REAR (SURROUND) L CENTER + + - - IMPEDANCE SELECTOR SET BEFORE POWER ON MAIN : 4 MIN. /SPEAKER CENTER : 6 MIN. /SPEAKER REAR : 6 MIN. /SPEAKER MAIN : 8 MIN. /SPEAKER CENTER : 8 MIN. /SPEAKER REAR : 8 MIN. /SPEAKER AC OUTLETS SWITCHED 120V 60Hz 0.8A MAX. TOTAL 100W MAX. TOTAL RCA Cable Color Codes DIGITAL Yellow = Video INPUT COAXIAL White = Left Audio CD Red = Right Audio OPTICAL DVD Optical Cable (Included) Yamaha DV-S5450 DVD Player (Rear Panel) RL AUDIO R L V VIDEO V-AUX VIDEO IN VCR OUT D-TV /CBL DVD MONITOR OUT VIDEO Use an RCA Video Cable And Jacks For Video Interconnections POWER 1 2 4 5 7 8 RETURN/RESUME 3 6 9 BIT RATE MENU ON SCREEN ENTER OK STOP PLAY PAUSE SUBTITLE ANGLE ZOOM AUDIO REPEAT Ñ A B SHUFFLE SCAN DVD Note: You will need the DVD remote to fully operate this system. Please refer to the DV-S5450 owner's manual for complete remote and DVD player instructions. PCM DIGITAL DTS MPEG AUDIO OUT 1 NOTE: Use the optical connection to enjoy 5.1 - channel surround sound 2 found on DVDs recorded in the Dolby Digital or DTS Digital Surround format. COAXIAL OPTICAL SUBWOOFER R 1 2 L VIDEO VIDEO OUT PR PB Y COMPONENT VIDEO S VIDEO Connecting Optical Cable *Analog Audio Out connections are required for playback of CD-Rs and recording from DVD to VCR. Dolby Digital is a trademark of Dolby Laboratories Licensing Corporation. DTS is a trademark of DTS Technology LLC. 6 Remove dust cap. NOTES: Align plug with terminal and insert cable. ∑ On both ends of the optical cable, align and firmly insert each plug into its mating terminal. ∑ During connection, do not bend the optical cable. ∑ Keep dust caps and reattach them if terminals are not used.