Yamaha YIT-W10 YIT-W10 Owners Manual - Page 5

LED Status Off An iPod or iPhone is not connected, or has stopped playing. However, lights up for 30 seconds or 2 minutes (depends on the iPod/iPhone) after connecting or stopping playback. Flashes green Connection in progress, continuously please wait. Flashes green Adjusting the volume level. once Lights up green A connection is established. You are ready to start playback of iPod on another Yamaha product. Lights up green and flashes red Flashes red for 2 seconds: An unsupported iPhone or iPod is connected. Keeps flashing red: Connection failed. Flashes red The battery of the iPod or (regardless of iPhone is low. green status) 4 Adjust the angle of your iPod or iPhone so that it is aligned parallel to PDX-50TX. ■ Group selection switch Use this switch to set the group ID. To establish a wireless connection (yAired) with another Yamaha product, set both the products to the same group. Group selection switch Match the group selection switch with the group ID to set. y • PDX-50TX supports "1" (A1), "2" (A2), and "3" (A3) on some Yamaha products that support "yAired". ■ Disconnecting the iPod or iPhone To disconnect the iPod or iPhone from PDX-50TX (transmitter), pull the iPod or iPhone upward. 5 To charge the iPod or iPhone, place it on PDX-50BC. y • Disconnection may be difficult under low temperature. In this case, do not disconnect the iPod or iPhone by force; loosen off the tab on the back of PDX-50TX to make the disconnection easier. 4 En