Yamaha YM-2400 Owner's Manual - Page 16
Insert the rails 2, 3 and 4 into the frame ends of the legs.
View all Yamaha YM-2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
YM-410D ASSEMBLY x Insert the rails (2), (3) and (4) into the frame ends of the legs. 2-1. First, insert the rail (2). Make sure that the end of the rail with the tone bar posts spaced further apart is positioned on the bass side. A mark "B" is printed on the large end face of the rail (2) and the groove section of the frame end of the large end leg. * Do not insert one side of the rail all the way down first, but push both sides into grooves alternately little by little until both sides are inserted fully and stop. Rail (4): With YAMAHA logo. Logo side facing the audience. (3): Both sides have clamps attached. The side with the shorter clamp should face the player. (2): Hole for attaching the stay. The side with the threaded hole should face the audience. (1) Tone bar posts High register side DC A Player side B Frame end Audience side Bass side 2-2. After confirming that legs on the left and right sides are vertical, use the screw to connect the end of the stay to the hole for attaching the stay in the long frame (2) and firmly tighten the screw. 2-3. Next, in the same way, insert the rails (3) and (4) securely. A mark "C" is printed on the large end face of the rail (3) and the groove section of the frame end of the large end leg, and a mark "D" for the rail (4). 2-4. Engage the short rail clamp located at the center of the rail (3) with the rail (2). Slant shaft Rail (2) 36