Yamaha YPP-200 Owner's Manual - Page 32

The Function Mode F7.5: Control Change ON/OFF ...Normally the YPP-200 will respond to MIDI control change data received from an external MIDI device or keyboard, causing the voice on the corresponding channel to be affected by pedal and other "control" settings received from the controlling device (the keyboard voice is not affected). The YPP-200 also transmits MIDI control change information when one of its pedals or other appropriate controls are operated. This function makes it possible to cancel control change data reception and transmission so that, for example, the YPP-200 pedals and other controls can be operated without affecting an external MIDI device. Use the [-/NO] and [+/YES] buttons to turn control change transmission and reception "On" or "OFF". Press the [-/NO] and [+/YES] buttons simultaneously to recall the default setting "On". • For information on control changes that can be used with the YPP-200, refer to the MIDI Data Format on page 41. F7.6: MIDI Transmit Transpose ...This function allows the MIDI note data transmitted by the YPP-200 to be transposed up or down in semitone increments by up to plus or minus 12 semitones. The pitch of the YPP-200 itself is not affected. Use the [-/NO] and [+/YES] buttons to set the desired amount of MIDI transmit transposition. The range is from "-12" (down one octave) through "0" (no transposition) to "12" (up one octave). Press the [-/NO] and [+/YES] buttons simultaneously to recall the default setting "0". F7.7: Panel/Status Transmit ...This function causes all the current YPP-200 panel settings (selected voice, etc.) to be transmitted via the MIDI OUT terminal. This is particularly useful if you will be recording performances to a MIDI sequence recorder such as the Yamaha MIDI Data Filer MDF3 which will be used to control the YPP-200 on playback. By transmitting the YPP-200 panel settings and recording them on the MIDI sequence recorder prior to the actual performance data, the YPP-200 will be automatically restored to the same settings when the performance is played back. Press the [+/YES] button to transmit the panel/status data. "End" will appear on the LED display when the data has been successfully transmitted. • See page 42 for list of the "Panel Data Contents" transmitted by this function. • Panel setting data that is transmitted to an external device can only be reloaded on a model of the same type. Panel setting data can also be directly transferred to or from instruments of the same model type. F7.8: Bulk Data Dump ...This function is used to transmit all data stored in the Recorder memory to a MIDI data storage device such as the Yamaha MIDI Data Filer MDF3, other sequence recorders, or MIDI compatible computers. Press the [+/YES] button to begin bulk transmission. "End" will appear on the LED display when the data has been successfully transmitted. • User song recorder data that is transmitted to an external device can only be reloaded on a model of the same type. Recorder data can also be directly transferred to or from instruments of the same model type. • The reload operation cannot be executed when the demo/preset song mode or user song recorder is in operation, or when the Function mode is engaged. • No MIDI note/panel data transmission or data reception occurs during a bulk data dump transmit operation. 32 YPP-200