Yamaha YSP-3050BL Owners Manual - Page 39
Error messages for AUTO SETUP
View all Yamaha YSP-3050BL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
■ Error messages for AUTO SETUP AUTO SETUP (IntelliBeam) Before the AUTO SETUP procedure starts Error message ERROR E-2 No MIC detected. Please check MIC connection and re-try. Cause The IntelliBeam microphone is not connected to this unit. Remedy Connect the IntelliBeam microphone to this unit. See page 30 While the AUTO SETUP procedure is in progress If one of the errors listed below except E-1 is displayed, press RETURN. In case you have started the AUTO SETUP procedure by pressing AUTO SETUP in step 3, run the procedure again from step 3 after the screen disappears. In case you have started the AUTO SETUP procedure by pressing MENU in step 3, run the procedure again from step 4 after the screen in step 3 is displayed. Run MANUAL SETUP if the problem is difficult to be solved. Error message Cause Remedy ERROR E-1 There is too much unwanted noise in Please test in quieter environment. your listening room. Make sure that your listening room is as quiet as possible. You may want to choose certain hours during the day when there is not much noise coming from outside. ERROR E-2 No MIC detected. Please check MIC connection and re-try. The IntelliBeam microphone was disconnected while the AUTO SETUP procedure was in progress. Make sure that the IntelliBeam microphone is firmly connected to this unit. ERROR E-3 Unexpected control is detected. Please re-try. Some other operations were performed on this unit while the AUTO SETUP procedure was in progress. Do not perform any other operations while the AUTO SETUP procedure is in progress. ERROR E-4 Please check MIC position. MIC should be set in front of YSP. The IntelliBeam microphone is not placed in front of this unit. Make sure that the IntelliBeam microphone is installed in front of this unit. ERROR E-5 Please check MIC position. MIC should be set above 1.8m/6.0ft. The IntelliBeam microphone is not placed in the right distance from this unit. Make sure that the IntelliBeam microphone is installed more than 1.8 m (6.0 ft) from the front of this unit and within 1 m (3.3 ft) from the center height of this unit. ERROR E-6 Volume level is lower than expected. Please check MIC position/connection and re-try. The IntelliBeam microphone cannot collect the sound produced by this unit because the sound output level is too low. Make sure that the IntelliBeam microphone is firmly connected to this unit and placed in a proper location. If the problem persists, contact the nearest authorized Yamaha service center for assistance. ERROR E-7 Unexpected error happened. Please re-try. An internal system error occurred. Repeat the AUTO SETUP procedure. See page - 30 - 30 30 30 - SETUP English 35 En