Yamaha YST SW215 MCXSP10 Manual - Page 15

Connecting to the INPUT1/OUTPUT terminals of the subwoofer For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the connections are faulty, no sound will be heard from the subwoofer or the speakers, or both of them. Make sure that the + and - polarity markings of the speaker cables are observed and set correctly. If these cables are reversed, the sound will be unnatural and lack bass. Caution Do not let the bare speaker wires touch each other, because this could damage the subwoofer or the amplifier, or both of them. ■Before connecting Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. Good No Good ■How to connect: 1 Loosen the terminal's knob, as shown in the figure. 2 Insert the bare wire. 3 Tighten the knob. 4 Test the firmness of the connection by pulling lightly on the cable at the terminal. Red: positive (+) Black: negative (-) CONNECTIONS U.S.A., Canada and Australia models only Banana Plug conection are also possible. 1 Tighten the terminal knob. 2 Simply insert the banana plug into the terminal.  1 Press and hold the terminal's tab, as shown in the figure. 2 Insert the bare wire. 3 Release your finger from the tab to allow it to lock securely on the cable's wire end. 4 Test the firmness of the connection by pulling lightly on the cable at the terminal. Red: positive (+) Black: negative (-)  Plug in the subwoofer to the AC outlet After all connections are completed, plug in the subwoofer and other audio/video components to the AC outlet. To AC outlet To AC outlet 12