Zanussi ZBB24431SV User Manual - Page 9
Problem, Possible cause, Solution
View all Zanussi ZBB24431SV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Problem There is too much frost and ice. Water flows on the rear plate of the refrigerator. Water flows into the refrigerator. Water flows on the floor. The temperature in the appliance is too low/too high. Possible cause Solution Food products placed in the appliance were too warm. The door is not closed correctly. The door is not closed correctly or the gasket is deformed/ dirty. The water drainage plug is not correctly positioned. Food products are not wrapped properly. Temperature is set incorrectly. During the automatic defrosting process, frost melts on the rear plate. The water outlet is clogged. Allow food products to cool to room temperature before storing. Refer to "Closing the door". Refer to "Closing the door". Position the water drainage plug in the correct way. Wrap the food products better. Refer to "Operation" chapter. This is correct. Clean the water outlet. Food products prevent that water flows into the water collector. The melting water outlet is not connected to the evaporative tray above the compressor. The temperature regulator is not set correctly. The door is not closed correctly. The food products' temperature is too high. Many food products are stored at the same time. The thickness of the frost is greater than 4-5 mm. The door has been opened often. There is no cold air circulation in the appliance. Make sure that food products do not touch the rear plate. Attach the melting water outlet to the evaporative tray. Set a higher/lower temperature. Refer to "Closing the door". Let the food products temperature decrease to room temperature before storage. Store less food products at the same time. Defrost the appliance. Open the door only if necessary. Make sure that there is cold air circulation in the appliance. 9