Zanussi ZFLX29K User Manual - Page 4

1 2 To replace the filter: 1. Remove the grease filters from the appliance. Refer to "Cleaning the grease filter" in this chapter. 2. Press the front edge in slot towards the bottom part of the filter. Slightly tilt the front of the filter downwards. 2. Slightly tilt the front of the filter downwards (2), then pull. Repeat the first two steps for all filters. 3. Clean the filters using a sponge with non abrasive detergents or in a dishwasher. The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, it has no influence on the performance of the appliance. 4. To mount the filters back follow the first two steps in reverse order. Repeat the steps for all filters if applicable. REPLACING THE CHARCOAL FILTER WARNING! The charcoal filter is nonwashable! ENVIRONMENTAL CONCERNS 3. To install a new filter, perform the same steps in reverse order. In any case, it is necessary to replace the filters at least every four months. REPLACING THE LAMP This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can be replaced by a technician only. In case of any malfunction refer to "Service" in the "Safety Instructions" chapter. Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. 4 *