Zanussi ZKH7146J Product Manaul - Page 20
Caution, Cleaning the water inlet filters, Important
View all Zanussi ZKH7146J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
When the container is full of water, put the drainage duct back again and empty the container. Do steps 3 and 4 again and again until no more water flows out from the drain pump. Clean the filter under the water tap and put it back in the pump into the special guides. Make sure that you tighten correctly the filter to prevent leakages. 1 2 Pull back the drainage duct. Unscrew the filter and remove it. Remove fluff and objects from the pump. Make sure that the impeller of the pump can turn. If this does not occur, contact the service centre. 1 2 Close the pump door. Caution! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When refitting the pump cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it. Cleaning the water inlet filters Important! If the appliance doesn't fill, takes long to fill with water, the starting button blinks yellow or the display (if available) shows the relevant alarm (see chapter "What to do if..." for more details), check if the water inlet filters are blocked . To clean the water inlet filters: • Turn off the water tap. • Unscrew the hose from the tap. • Clean the filter in the hose with a stiff brush. • Screw the hose back onto the tap. Make sure the connection is tight. 20 www.zanussi.com