Zanussi ZWI71201WA Product Manaul - Page 24
Service Force Centre. The joining piece must - dishwasher
View all Zanussi ZWI71201WA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
38 mm (1.5") standpipe diamater 30 cm (12") The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm. If the outlet spigot has not been used before, remove any blanking plug that may be in place. Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see above) to prevent waste from the sink entering the appliance. If you intend to drain the hose from the machine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic "U - Piece" supplied. Min. 60 cm (23.6") Max. 90 cm (35.4") If your drain hose looks like this (see beside) you do not require the "U" piece". Just push the hose firmly in to the standpipe. 2. Onto a sink outlet spigot. In the interest of the environment The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river. It is essential that these appliances are not connected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution. If you require any further advice please contact your local water authority. SHOWER BATH SINK TOILET BIDET Loop RAINWATER 'RUN-OFF' WASHING MACHINE DISHWASHER SURFACE WATER DRAINS & SEWERS UNTREATED DISCHARGE RIVER FOUL DRAIN FOUL SEWERS SEWAGE TREATMENT WORKS TREATED DISCHARGE RIVER 24 www.zanussi.com