Zanussi ZWT71401WA Product Manaul - Page 16

Use - Drying

Get Zanussi ZWT71401WA PDF manuals and user guides View all Zanussi ZWT71401WA manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Cancelling a programme Turn the selector dial to to cancel a programme which is running. Now you can select a new programme. Opening the door after the programme has started First set the machine to pause by pressing the button 7. If the pilot light 9 blinks and after a few minutes goes off, the door can be opened. If the pilot light 9 remains lit, this means that the machine is already heating or that the water level is too high. In any case, do not try to force the door open! If you cannot open the door but you need to open it, you have to switch the machine off by turning the selector dial to . After a few minutes the door can be opened. (Pay attention to the water level and temperature!). After closing the door, it is necessary to select the programme and options again and to press button 7. At the end of the programme The machine stops automatically. The blinking appears on the display, the pilot light of but- ton 7 and the pilot light 9 go off. Use - Drying If a programme or an option that ends with water left in the tub has been selected, the pilot light 9 remains on and the door is locked to indicate that the water must be emptied out before opening the door. Before you empty out the water, the drum continues to run at regular intervals until the water draining. Follow the below instructions to empty out the water: 1. Turn the programme selector dial to . 2. Select the draining or spinning programme. 3. Reduce the spin speed if needed, by pressing the relevant button. 4. Press button 7. At the end of the programme, the door is released and can be opened. Turn the programme selector dial to to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. Drying only The recommended load size is 3 kg for cottons and linen and 2 kg for synthetic items. By pressing Drying Time button it is also possible to dry up to 4 kg of cotton items (see the «Drying Programme » table). Caution! The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. 1. Load the laundry. 2. Set the spin programme at the maximum spin speed allowed for the type of laundry to remove any residual moisture and obtain the best drying performances. 3. Set the drying programme for Cottons or Synthetic in the Drying sector of the programme selector dial. 4. Set the drying time by pressing button 5 until the time you want appears on the display (see the «Drying Programme» table). Every time you press this button the drying time increases by 5 minutes. The programme time will automatically increase by some minutes. 5. Press button 7 to start the programme. The time remaining is updated every minute. 6. At the end of the programme, the buzzer sounds. The blinking appears on the display. The door pilot light 9 is on. 16 www.zanussi.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Cancelling a programme
Turn the selector dial to
to cancel a pro-
gramme which is running. Now you can select a
new programme.
Opening the door after the programme
has started
First set the machine to pause by pressing the
button
7
.
If the pilot light
9
blinks and after a few minutes
goes off, the door can be opened.
If the pilot light
9
remains lit, this means that the
machine is already heating or that the water lev-
el is too high. In any case, do not try to force
the door open!
If you cannot open the door but you need to
open it, you have to switch the machine off by
turning the selector dial to
. After a few mi-
nutes the door can be opened.
(Pay attention to the water level and tem-
perature!).
After closing the door, it is necessary to select
the programme and options again and to press
button
7
.
At the end of the programme
The machine stops automatically. The blinking
appears on the display, the pilot light of but-
ton
7
and the pilot light
9
go off.
If a programme or an option that ends with wa-
ter left in the tub has been selected, the pilot
light
9
remains on and the door is locked to in-
dicate that the water must be emptied out be-
fore opening the door.
Before you empty out the water, the drum con-
tinues to run at regular intervals until the water
draining.
Follow the below instructions to empty out the
water:
1.
Turn the programme selector dial to
.
2.
Select the draining or spinning programme.
3.
Reduce the spin speed if needed, by
pressing the relevant button.
4.
Press button
7
.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
to switch the ma-
chine off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
Use - Drying
Drying only
The recommended load size is 3 kg for
cottons and linen and 2 kg for synthetic
items.
By pressing
Drying Time
button it is also pos-
sible to dry up to 4 kg of cotton items (see the
«Drying Programme » table).
Caution!
The water tap must be open and
the drain hose must be positioned in the
sink or connected to the drain pipe.
1.
Load the laundry.
2.
Set the spin programme at the maximum
spin speed allowed for the type of laundry
to remove any residual moisture and obtain
the best drying performances.
3.
Set the drying programme for Cottons or
Synthetic in the Drying sector of the pro-
gramme selector dial.
4.
Set the drying time by pressing button
5
until the time you want appears on the dis-
play (see the «Drying Programme» table).
Every time you press this button the drying
time increases by 5 minutes.
The programme time will automatically in-
crease by some minutes.
5.
Press button
7
to start the programme. The
time remaining is updated every minute.
6.
At the end of the programme, the buzzer
sounds. The blinking
appears on the dis-
play. The door pilot light
9
is on.
16
www.zanussi.com