ZyXEL NWA-3160 User Guide - Page 277
Resetting the NWA3000-N series AP
View all ZyXEL NWA-3160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 277 highlights
Chapter 21 Troubleshooting Wireless clients are not being load balanced among my APs. • Make sure that all the APs used by the wireless clients in question share the same SSID, security, and radio settings. • Make sure that all the APs are in the same broadcast domain. • Make sure that the wireless clients are in range of the other APs; if they are only in range of a single AP, then load balancing may not be as effective. In the Monitor > Wireless > AP Information > Radio List page, there is no load balancing indicator associated with any APs assigned to the load balancing task. • Check to be sure that the AP profile which contains the load balancing settings is correctly assigned to the APs in question. • The load balancing task may have been terminated because further load balancing on the APs in question is no longer required. 21.6 Resetting the NWA3000-N series AP If you cannot access the NWA3000-N series AP by any method, try restarting it by turning the power off and then on again. If you still cannot access the NWA3000-N series AP by any method or you forget the administrator password(s), you can reset the NWA3000-N series AP to its factory-default settings. Any configuration files or shell scripts that you saved on the NWA3000-N series AP should still be available afterwards. Use the following procedure to reset the NWA3000-N series AP to its factorydefault settings. This overwrites the settings in the startup-config.conf file with the settings in the system-default.conf file. Note: This procedure removes the current configuration. 1 Make sure the PWR\SYS LED is on and not blinking. 2 Press the RESET button and hold it until the PWR\SYS LED begins to blink. (This usually takes about five seconds.) 3 Release the RESET button, and wait for the NWA3000-N series AP to restart. You should be able to access the NWA3000-N series AP using the default settings. NWA3000-N Series User's Guide 277