ZyXEL P-202U User Guide - Page 204
Setting Up Default Dial-in
View all ZyXEL P-202U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
P-202H Plus v2 User's Guide 22.3 Setting Up Default Dial-in From the Main Menu, enter 13 to go to Menu 13 - Default Dial-in Setup. This section describes how to configure the protocol-independent fields in this menu. For the protocoldependent fields, refer to the appropriate chapters. Figure 97 Menu 13 Default Dial-in Setup Menu 13 - Default Dial-in Setup Telco Options: CLID Authen= None PPP Options: Recv Authen= CHAP/PAP Compression= Yes Mutual Authen= No O/G Username= O/G Password= ******** Multiple Link Options: Max Trans Rate(Kbps)= 128 IP Address Supplied By: Dial-in User= Yes IP Pool= No IP Start Addr= N/A IP Count(1,4)= N/A Session Options: Edit Filter Sets= No Callback Budget Management: Allocated Budget(min)= Period(hr)= Press ENTER to Confirm or ESC to Cancel: The following table describes the fields in this menu. Table 71 Menu 13 Default Dial-in Setup FIELD Telco Options: CLID Authen PPP Options: Recv Authen DESCRIPTION This field sets the CLID authentication parameter for all incoming calls. There are three options for this field: None - No CLID is required. Required - CLID must be available, or the ZyXEL Device will not answer the call. Preferred - If the CLID is available then CLID will be used; otherwise, authentication is performed in PPP negotiation. This field sets the authentication protocol for incoming calls. For security reason, setting authentication to None is strongly discouraged. Options for this field are: CHAP/PAP - Your ZyXEL Device will try CHAP first, but PAP will be used if CHAP is not available. CHAP -Use CHAP only. PAP - Use PAP only. None - Your ZyXEL Device tries to acquire CHAP/PAP first, but no authentication is required if CHAP/PAP is not available. 203 Chapter 22 Dial-in Setup