ZyXEL ZYWALL USG 200 User Guide - Page 475

Chapter 25 IPSec VPN SA). Click a column's heading cell to sort the table entries by that column's criteria. Click the heading cell again to reverse the sort order. Figure 353 Configuration > VPN > IPSec VPN > VPN Connection Each field is discussed in the following table. See Section 25.2.2 on page 483 and Section 25.2.1 on page 476 for more information. Table 126 Configuration > VPN > IPSec VPN > VPN Connection LABEL DESCRIPTION Use Policy Route to control dynamic IPSec rules Select this to be able to use policy routes to manually specify the destination addresses of dynamic IPSec rules. You must manually create these policy routes. The ZyWALL automatically obtains source and destination addresses for dynamic IPSec rules that do not match any of the policy routes. Clear this to have the ZyWALL automatically obtain source and destination addresses for all dynamic IPSec rules. See Section 6.4.2 on page 98 for how this option affects the routing table. Ignore ""Don't Fragment"" setting in packet header Select this to fragment packets larger than the MTU (Maximum Transmission Unit) that have the "don't" fragment" bit in the IP header turned on. When you clear this the ZyWALL drops packets larger than the MTU that have the "don't" fragment" bit in the header turned on. Add Click this to create a new entry. Edit Double-click an entry or select it and click Edit to open a screen where you can modify the entry's settings. Remove To remove an entry, select it and click Remove. The ZyWALL confirms you want to remove it before doing so. Activate To turn on an entry, select it and click Activate. Inactivate To turn off an entry, select it and click Inactivate. Connect To connect an IPSec SA, select it and click Connect. Disconnect To disconnect an IPSec SA, select it and click Disconnect. ZyWALL USG 100/200 Series User's Guide 475