ZyXEL ZyWALL 2WG User Guide - Page 516
Edit Filter Sets, Menu 11.1.4 - Remote Node Filter
View all ZyXEL ZyWALL 2WG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 516 highlights
Chapter 34 Remote Node Setup Table 187 Remote Node Network Layer Options Menu Fields (continued) FIELD DESCRIPTION Private This field is valid only for PPTP/PPPoE encapsulation. This parameter determines if the ZyWALL will include the route to this remote node in its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast. If No, the route to this remote node will be propagated to other hosts through RIP broadcasts. RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP direction from Both/ None/In Only/Out Only. See Chapter 6 on page 131 for more information on RIP. The default for RIP on the WAN side is None. It is recommended that you do not change this setting. Version Press [SPACE BAR] and then [ENTER] to select the RIP version from RIP-1/RIP-2B/ RIP-2M or None. Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish membership in a Multicast group. The ZyWALL supports both IGMP version 1 (IGMPv1) and version 2 (IGMP-v2). Press [SPACE BAR] to enable IP Multicasting or select None to disable it. See Chapter 6 on page 131 for more information on this feature. Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER] at the message "Press ENTER to Confirm..." to save your configuration and return to menu 11, or press [ESC] at any time to cancel. 34.5 Remote Node Filter Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to Yes. Press [ENTER] to open Menu 11.1.4 - Remote Node Filter. Use menu 11.1.4 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to 4 filter sets separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field. For more information on defining the filters, please refer to Chapter 38 on page 541. For PPPoE or PPTP encapsulation, you have the additional option of specifying remote node call filter sets. Figure 335 Menu 11.1.4: Remote Node Filter (Ethernet Encapsulation) Menu 11.1.4 - Remote Node Filter Input Filter Sets: protocol filters= device filters= Output Filter Sets: protocol filters= device filters= Enter here to CONFIRM or ESC to CANCEL: 516 ZyWALL 2 Plus User's Guide