ZyXEL omni.net D User Guide - Page 53
Special MNP compatibility. see also S27.0, S38.5, Enable UK Australian, Singapore, Indian, etc., type
View all ZyXEL omni.net D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Omni 56K Plus Series User's Guide Table 4-16 Extended S-Registers "ATSn=x" COMMAND BIT DEC HEX FUNCTION AND DESCRIPTION REF. 6 64 40 Enables type 4 ring detection. S41= bit dec hex Bit mapped register. +000 0 1 1 Special MNP compatibility. (see also S27.0, S38.5) &Kn 3 8 8 Enable CCITT signals 140 and 141 on EIA-232D interface. 4 16 10 In X2-X7 setting, modem waits for S6 seconds before dialing and ignores dial tone detection. 5 32 20 DSR follows DCD and pulses for 0.5 sec after DCD on- &Sn off transition. 6 64 40 Force S0>=2; doesn't answer on the first ring. S0 7 128 80 Ignore calling tone, not to be used as fax detection. S42= bit dec hex Bit mapped register. +000 1 2 2 Enables throughput averaging. 2 4 4 CND message will be forced on even if ATQ2 is set. 3 8 8 Disable escape sequence code in answer mode. 4 16 10 Disable V.17 14,400 Fax in calling mode, no effect to answering mod. 5 32 20 Disable Data/Voice button switch. 6 64 40 Disable 'RINGING' result code. Xn 7 128 80 DCD forced on but pulse off for 0.5 seconds at carrier &C0 loss. S43= bit dec hex Bit mapped register. +008 6 64 40 Enable 1.5 sec, pause between off-hook and modem answering. 7 128 80 Modem hang-up if the line condition does not permit modem to run at the highest speed set by '&Nn' command. S44= bit dec hex Bit mapped register. +000 3 8 8 ATDSn initiates auto-dial of the stored numbers DSn consecutively until connection is made (cyclic dial). 4 16 10 DSR follows DTR. (See also S41.5) &S1 6 64 40 When selected with '&B0', DTE speed fixed at 38400 &Bn when the link speed is above 9600. DTE speed fixed at 9600 if link speed is 7200. If it is below 7200, DTE speed follows link speed. When selected with &B1, DTE speed fixed at current rate when an ARQ connection is made, when a non-ARQ connection is made, DTE speed follows the link speed. (See also S18) 7 128 80 Enable UK (Australian, Singapore, Indian, etc.,) type "short-short ring" ring-back detection. S45= dec hex Delay during which the CND silence detection is 0-255 0-FF disabled, in 20 ms units. (See also S46) +100 Command Sets 4-25