Home » eMachines Manuals » Desktops » eMachines ET1831 » Manual Viewer

eMachines ET1831 eMachines Desktop User's Guide - Page 4

Product servicing, Telephone line safety - power supply

Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

: Warning! The grounding pin is a safety feature. Using a power outlet that is not properly grounded may result in electric shock and/or injury. Note: The grounding pin also provides good protection from unexpected noise produced by other nearby electrical devices that may interfere with the performance of this product. • Use the product only with the supplied power supply cord set. If you need to replace the power cord set, make sure that the new power cord meets the following requirements: detachable type, UL listed/CSA certified, type SPT-2, rated 7 A 125 V minimum, VDE approved or its equivalent, 4.6 meters (15 feet) maximum length. Product servicing Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to qualified service personnel. Unplug this product from the wall outlet and refer servicing to qualified service personnel when: • the power cord or plug is damaged, cut or frayed • liquid was spilled into the product • the product was exposed to rain or water • the product has been dropped or the case has been damaged • the product exhibits a distinct change in performance, indicating a need for service • the product does not operate normally after following the operating instructions Note: Adjust only those controls that are covered by the operating instructions, since improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal condition. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. Telephone line safety • Disconnect all telephone lines from the equipment when not in use and/or before servicing. • To avoid the remote risk of electric shock from lightning, do not connect the telephone line to this equipment during lightning or thunderstorms. ii

Section	Page
Contents	9
Checking Out Your Computer	11
About this guide	12
Product Registration	12
Front	13
Back	14
Setting Up and Getting Started	16
Working safely and comfortably	17
Avoiding discomfort and injury from repetitive strain	17
Preparing power connections	18
Protecting from power source problems	18
Checking the voltage selection	19
To set the voltage selection switch:	19
Connecting to a broadband modem or network	20
To connect to a broadband modem or to an Ethernet network:	20
Connecting a dial-up modem	20
To connect the modem:	20
Using the World Wide Web	21
Connecting to a Web site	22
To connect to a Web site:	22
Downloading files	23
To download files or programs from a Web site:	23
Ethernet networking	24
Wired Ethernet networking	24
Ethernet, Fast Ethernet, or Gigabit Ethernet	24
Using a router	24
Example router-based Ethernet network	24
Equipment you need for a router-based Ethernet network	25
Determining if an Ethernet card is already installed on your computer	26
Setting up wired Ethernet network hardware	26
Making sure your broadband connection works	26
Installing Ethernet cards and drivers	26
Connecting network cables	27
Setting up a network using a router	27
To set up a network using a router:	28
Establishing your Ethernet network connection	29
Naming the computers and the workgroup	29
Configuring the TCP/IP protocol	29
Using a DHCP server	29
Configuring your router	29
Testing your network	29
Adding a printer to your network	30
Sharing resources	30
Sharing drives and printers	30
Sharing drives or folders	30
To share drives or folders:	30
Un-sharing drives and folders	31
To un-share drives or folders:	31
Using the network	32
Viewing shared drives and folders	32
To view shared drives and folders:	32
Creating a shortcut to a network drive	32
To map a network drive:	32
Opening files across the network	33
To open files across the network:	33
Copying files across the network	33
To copy files across the network:	33
Printing files across the network	33
To print files across the network:	33
Troubleshooting	34
First steps	35
Troubleshooting	35
Add-in cards	36
The computer does not recognize an add-in card	36
Audio	36
CD or DVD drives	36
DVD drives	36
Ethernet	36
You cannot see the other computers on your network	36
The computer does not recognize an add-in Ethernet card	37
Your Ethernet network is running slower than you expect	37
Expansion cards	38
The computer does not recognize an expansion card	38
File management	38
A file was accidentally deleted	38
To restore deleted files:	38
Hard drive	38
You see an “Insufficient disk space” error message	38
You see a “Data error” message	39
The hard drive cannot be accessed, or you see a “General failure reading drive C” error message	39
You see a “Non-system disk” or “disk error” error message	40
Internet	40
You cannot connect to the Internet	40
You see an “Unable to locate host” message and are unable to browse the Internet	41
Connecting to a Web site takes too long	41
People are sending you e-mail messages, but you have not received any mail	41
Keyboard	42
The keyboard does not work	42
A keyboard character keeps repeating or you see a “keyboard stuck” or “key failure” error message	42
Liquid spilled in the keyboard	42
Memory	42
You see a “Memory error” message	42
You see a “Not enough memory” error message	43
Memory card reader	43
Drive letters for the memory card slots do not appear in the My Computer window	43
Modem (cable or DSL)	43
Modem (dial-up)	43
Your modem does not dial or does not connect	43
You cannot connect to the Internet	45
Your 56K modem does not connect at 56K	45
Your fax communications program only sends and receives faxes at 14,400 bps when you have a 56K modem	45
The modem is not recognized by your computer	46
The modem is noisy when it dials and connects	46
Monitor	46
The screen resolution is not correct	46
The computer is running but there is no picture	46
The color is not uniform	47
The text on the display is dim or difficult to read	47
Mouse	47
The mouse does not work	47
The mouse works erratically	48
Networks	48
You cannot connect to your company network	48
Optical disc drives	48
The computer does not recognize a disc or the CD or DVD drive	48
An audio CD does not produce sound	49
A DVD movie will not play	49
Passwords	50
Your computer does not accept your password	50
Power	50
Your computer will not turn on	50
Printer	51
The printer will not turn on	51
The printer is on but will not print	51
You see a “Printer queue is full” error message	51
You see a “Printer is out of paper” error message	51
Sound	52
You are not getting sound from the speakers	52
Recovering your system	53
To recover your system:	53
Creating recovery discs	54
To create recovery discs:	54
Recovering pre-installed software and drivers	55
To recover your pre-installed software and drivers:	55
Returning your system to its factory condition	56
Recovering from within Windows OS	56
To reinstall Windows OS and all pre-installed software and drivers:	56
Recovering from the hard drive during startup	57
To reinstall Windows OS and all pre-installed software and drivers:	57
Recovering from your recovery discs	57
To reinstall Windows OS and all pre-installed software and drivers:	57
Telephone support	58
Before calling Customer Care	58
Self-help	59

Match case Limit results 1 per page

Warning! The grounding pin is a safety feature. Using a power

outlet that is not properly grounded may result in electric shock

and/or injury.

Note:

The grounding pin also provides good protection from

unexpected noise produced by other nearby electrical devices that

may interfere with the performance of this product.

•

Use the product only with the supplied power supply cord set. If you need to

replace the power cord set, make sure that the new power cord meets the

following requirements: detachable type, UL listed/CSA certified, type SPT-2,

rated 7 A 125 V minimum, VDE approved or its equivalent, 4.6 meters (15

feet) maximum length.

Product servicing

Do not attempt to service this product yourself, as opening or removing covers

may expose you to dangerous voltage points or other risks. Refer all servicing to

qualified service personnel.

Unplug this product from the wall outlet and refer servicing to qualified service

personnel when:

•

the power cord or plug is damaged, cut or frayed

•

liquid was spilled into the product

•

the product was exposed to rain or water

•

the product has been dropped or the case has been damaged

•

the product exhibits a distinct change in performance, indicating a need for

service

•

the product does not operate normally after following the operating

instructions

Note:

Adjust only those controls that are covered by the operating

instructions, since improper adjustment of other controls may result

in damage and will often require extensive work by a qualified

technician to restore the product to normal condition.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace

only with the same or equivalent type recommended by the

manufacturer. Dispose of used batteries according to the manufacturer’s

instructions.

Telephone line safety

•

Disconnect all telephone lines from the equipment when not in use and/or

before servicing.

•

To avoid the remote risk of electric shock from lightning, do not connect the

telephone line to this equipment during lightning or thunderstorms.