eMachines RB-L-ET.DE2HY.002 8512499 - eMachines Flat Panel Monitor User Guide - Page 13
Adjusting monitor tilt tension, For optimum viewing
UPC - 846154036911
View all eMachines RB-L-ET.DE2HY.002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
www.emachines.com 2 Insert a Phillips screwdriver through the access hole in the base and onto the height tension screw (on the back of the stand, in the slot above the USB In port). Height tension screw 3 Adjust the height tension screw so the monitor stays in place when you let go. If the monitor lowers by itself when you let go, turn the screw clockwise several complete turns. If the monitor rises when you let go, turn the screw counter-clockwise several complete turns. You may need to turn the screw several times before the tension is correct for your size of monitor. 4 Adjust the height tension screw so the raising and lowering forces are equal. After the forces are equalized, turn the tension screw clockwise two to four turns to slightly decrease the lifting tension. 5 Replace the screwdriver access hole cap. 6 For optimum viewing, adjust the height so the top of the monitor is about 1 inch (2.5 cm) below eye level. Adjusting monitor tilt tension To adjust your monitor's tilt tension: • Adjust the tilt tension screw (on the top of the stand) so the monitor stays in place when you let go. If the monitor changes its tilt angle when you let go, turn the screw clockwise one complete turn to increase the tension. Tilt tension screw 9