eMachines T3114 NG3 Hardware Reference - Page 177
Rotate the I/O panel up until its screw hole aligns with the screw hole in, the front of the case
View all eMachines T3114 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 177 highlights
CHAPTER 13: Adding and Replacing Components www.emachines.com 5 Disconnect the front I/O panel cables from the system board. 170 6 Remove the single screw that secures the front I/O panel to the case. Screw 7 Rotate the I/O panel down until it faces the tabletop, then pull the I/O panel and its cables away from the case. Note the location of the hole through which the cables are threaded. 8 Thread the new I/O panel's cables through the hole in the case, then insert the tabs in the bottom of the I/O panel into the slots in the front of the case. 9 Rotate the I/O panel up until its screw hole aligns with the screw hole in the front of the case, then secure it to the case with the screw. 10 Reconnect the I/O panel's cables to the appropriate connectors on the system board.