eMachines T6000 NG3 Hardware Reference - Page 174
Replacing the heat sink
View all eMachines T6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
www.emachines.com Tips & Tricks On some models, you may first need to remove the heat sink fan. Replacing the heat sink 5 Pull down on the side of the power supply nearest you, then remove the power supply from the bay. 6 Slide the new power supply into the power supply bay until its back is flush with the back of the case. 7 Use the four screws you removed previously to secure the new power supply to the case. 8 Reconnect the power supply cables to the system board and to the drives. 9 Replace the side panel by following the instructions in "Replacing the side panel" on page 157. Replacing the heat sink Tips & Tricks You need a Phillips screwdriver to add or replace the heat sink. To replace the heat sink: 1 Remove the side panel by following the instructions in "Removing the side panel" on page 154. 2 Place the computer case on its side. 3 Disconnect the heat sink fan's power connector from the system board. Connector 167