iPod iH8LR Blue USB User Guide - Page 9

Troubleshooting Symptom iH8 does not turn on iH8 doesn't respond Possible Problem Solution AC adaptor isn't plugged into a working wall socket Plug the AC adaptor into a working wall socket and plug the or not plugged into the power supply jack on back connector into the supply jack on the unit of the unit iH8 requires a reset If unit is plugged in and doesn't respond, try resetting the unit by following these steps: a) remove iPod from dock b) unplug unit from power source c) remove back up batteries d) wait 1 hour, then resume use iPod is not docked properly Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock. Battery Low icon always Batteries are weak flashing Batteries were not installed properly iPod does not respond to the unit/iPod is playing but no sound comes out iPod is not docked properly Your iPod software is too old iPod is locked up/plays but no sound comes out Using 1st or 2nd generation iPod, iPod Shuffle or other devices. Remote Control didn't work Battery weak Remote Control is out of range of the iH8 remote sensor iH8/iPod performance is The iH8 is reacting to external interference erratic No sound from iH8 Volume is set too low on iH8 iPod didn't charge up iPod is not installed properly Replace with new batteries Check to make sure the polarity ( + and - ends) matches the diagram in the battery compartment Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock. Upgrade software on your iPod. For details visit http://www.apple.com/ipod/download Check the volume setting. Make sure your iPod is working properly before docking into the unit. Please refer to your iPod manual for details. See above for software upgrade information. You may need to reset your iPod. To do so: 1. Toggle the Hold switch to hold position, then off. 2. Press and hold the Menu and center Select buttons at the same time until Apple logo appears. You may need to repeat this step. iH8 cannot control those iPods or other devices. Replace current battery with new battery Move within 30 feet of the unit. Move unit away from potential sources of external interference such as computers, modems, wireless devices (routers) or fluorescent light. Make sure volume is turned up Remove your iPod from the dock and check for obstruction on the connectors in the dock and on your iPod. Then reseat it in the dock. No AM band radio sound but others OK AM band radio is very noisy iPod is locked up/ frozen iPod battery has problem AM loop antenna is not connected to the unit AM loop antenna isn't located properly Please make sure your iPod is working properly before docking into the unit. Please refer to your iPod manual for details. Plug the AM loop antenna connector to the jack on the back of the unit Move the AM loop antenna away from the main unit/iPod and rotate it for best reception 7