1994 Buick LeSabre Owner's Manual - Page 230

2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper 1evel.It doesn't take much fluid, generally less than a pint (OSL). Don't overfill. We recommend you use only fluid labeled DEXRON@-I11or DEXRON@-IIE,because fluids with that label are made especially for your automatic transaxle. Damage caused by fluid other than DEXRON@-I11 orDEXRON@-IIEis not covered by your new vehicle warranty. 0 After adding fluid, recheck the fluid level as described under "How to Check." When the correct fluid level is obtained, push the dipstick back in all the way. 3. Check both sides of the dipstick, and read the lower level. The fluid level must be in the cross-hatched area. 4. If the fluid level is in the acceptable range, push the dipstick back in all the way. 0 Engine Coolant The following explains your cooling system and how to add coolant when it is low. If you have a problem with engine overheating, see "Engine Overheating" in the Index. The proper coolant for Buick your will: 0 How to Add Fluid Refer to the Maintenance Schedule to determine what kind of transaxle fluid to use. See "Recommended Fluids and Lubricants" in the Index. If the fluid level is low, add only enough of the proper fluid to bring the level into the cross-hatched area on the dipstick. 1. Pull out the dipstick. Give freezing protection down to -34°F (-37°C). Give boiling protection up to 262°F (128°C). Protect against rust and corrosion. Help keep the proper engine temperature. 0 0 228