1997 Buick Riviera Owner's Manual - Page 152

RECALL: Press this button briefly to recall the station being played or to display clock. To change what is the normally shown on the display (station or time), press see the RECALL button until you the display you want, RECALL button untilthe display flashes. then hold the If you press the button when the ignition isoff, the clock will show for a few seconds. Finding a Station to AM-FM: Press this button switch between AM, F M 1 and FM2.The display shows your selection. TUNE: Press the up or down arrow to choose radio stations. SEEK: Press the up or down arrow to go to the next higher or lower station and stay there. sound will The mute while seeking. SCAN: Press oneof the SEEK arrows for two seconds and SCAN will appearon the display. UseSCAN to listen to stationsfor a few seconds. The radio willgo to a station, stop a few seconds, then go to the next for on station. Pressone of the SEEK arrows again to stop scanning. The sound will mute while scanning. PUSHBUTTONS: The six numbered pushbuttons let you return to your favorite stations. You can set up to 18 stations (sixAM, six FM1 and six FM2). Just: 1. Turn the radio on. 2. Press AM-FM to select the band. 3. Tune in the desired station. 4. Press TONE to selectthe setting you prefer. 5. Press and holdone of the six numbered buttons. The sound will mute. When returns, release the button. it Whenever you press that numbered button, the station you set will return and the tone you selecte will be automatically selected that button. for 6. Repeat the steps for each pushbutton. P SCAN:Press this button to listen to each of your preset stationsfor a few seconds. radio will go to The the f i s t preset station, stop for a few seconds, then go on to the next preset station. PressSCAN again to P stop scanning.If a preset station has weak reception, th radio will not stop the preset station. at AUTO SET Press this button and the system will seek and set the 12 strongest F M or the 6 strongest AM stations on your preset buttons. AUTO will flash SET while seeking and will remain until this function is on complete. To return to the stations you manually set, press AUTO SET again. 3-11