1997 Buick Riviera Owner's Manual - Page 272

Headlamps 1. Loosen the bolts on the inboard edge headlamp two of the assembly. This allows you to pull out the assembly for more hand clearance when changing bulbs. 2. Reach into the assembly and turn the bulb socket one-quarter of a turn toward the center of the engine compartment, while pressing it firmly. The right high-beam headlamp access area next to the is radiator pressure cap. 3. Remove the wire connector from the bulb by lifting the the lock tab and pulling it away fiom plastic base. The right low-beam headlamp access area is to the right 5. Turn the bulb socket one-quarterof a turn making and slightly behind high beam area. the sure the tab is properly engaged in the panel slot. The left high-beam headlamp access is located near area 6. To reassemble, attach the wire connector to the (A) the air cleaner. (B) plastic base making sure the lock tab is over the The left low-beam headlamp access area behind and is lock (C). between the high-beam area and a r cleaner, the i 4. Install the bulb by putting the small tab into the (D) small notchin the lamp (E). 6-35