2015 Buick LaCrosse Owner Manual - Page 165

5-52 Instruments and Controls button is pressed, then programming is complete. There is no need to complete Steps 4-6. . hand-held transmitter was supplied by the manufacturer of the garage door opener receiver. 2. At the same time, press and hold both the hand-held transmitter button and one of the three Universal Remote system buttons to be used to operate the garage door. Do not release either button until the indicator light changes from a slow to a rapid flash. Then release both buttons. Some garage door openers may require substitution of Step 2 with the procedure under in "Radio Signals for Canada and Some Gate Operators" later in this section. 3. Press and hold the newly programmed Universal Remote system button for five seconds while watching the indicator light and garage door activation. . If the indicator light does not come on or the garage door does not move, a second button press may be required. For a second time, press and hold the newly programmed button for five seconds. If the light stays on or the garage door moves, programming is complete. If the indicator light blinks rapidly for two seconds, then changes to a solid light and the garage door does not move, continue with programming Steps 4-6. Learn or Smart Button 4. After completing Steps 1-3 , locate the Learn or Smart button inside the garage on the garage door opener receiver. The name and color of the button may vary by manufacturer. 5. Press and release the Learn or Smart button. Step 6 must be completed within 30 seconds of pressing this button. 6. Inside the vehicle, press and hold the newly programmed Universal Remote system button for two seconds and then release it. If the garage door does not move or the lamp on the garage door opener receiver . If the indicator light stays on continuously or the garage door moves when the