2015 Buick LaCrosse Owner Manual - Page 344

Vehicle Care Coated Moldings Coated moldings should be cleaned. . 10-91 To clean: 1. Saturate a clean lint-free colorfast cloth with water. Microfiber cloth is recommended to prevent lint transfer to the fabric or carpet. 2. Remove excess moisture by gently wringing until water does not drip from the cleaning cloth. 3. Start on the outside edge of the soil and gently rub toward the center. Fold the cleaning cloth to a clean area frequently to prevent forcing the soil in to the fabric. 4. Continue gently rubbing the soiled area until there is no longer any color transfer from the soil to the cleaning cloth. 5. If the soil is not completely removed, use a mild soap solution followed only by plain water. If the soil is not completely removed, it may be necessary to use a commercial upholstery When lightly soiled, wipe with a sponge or soft lint-free cloth dampened with water. When heavily soiled, use warm soapy water. cleaner or spot lifter. Test a small hidden area for colorfastness before using a commercial upholstery cleaner or spot lifter. If ring formation occurs, clean the entire fabric or carpet. Following the cleaning process, a paper towel can be used to blot excess moisture. . Fabric/Carpet/Suede Start by vacuuming the surface using a soft brush attachment. If a rotating brush attachment is being used during vacuuming, only use it on the floor carpet. Before cleaning, gently remove as much of the soil as possible using one of the following techniques: . Cleaning High Gloss Surfaces and Vehicle Information and Radio Displays For vehicles with high gloss surfaces or vehicle displays, use a microfiber cloth to wipe surfaces. Before wiping the surface with the microfiber cloth, use a soft bristle brush to remove dirt that could scratch the surface. Then use the microfiber cloth by gently rubbing to clean. Never use window cleaners or solvents. Periodically hand wash the microfiber cloth separately, using mild soap. Do not use bleach or fabric softener. Rinse thoroughly and air dry before next use. Gently blot liquids with a paper towel. Continue blotting until no more soil can be removed. For solid soils, remove as much as possible prior to vacuuming. .