1995 Cadillac Fleetwood Owner's Manual - Page 136

RCL: Press this button briefly to recall the station being played or the clock display. To change what normally is shown on the display (station or time), press the button until you seethe &splay you want. Then, hold the button until the display flashes.If you press the button when the ignition is off, the clock will show for a few seconds. AM-FM: Press this button to get AM, FMl or FM2. The display shows your selection. You may also press AM-FM to switch between the radio and tape when a tape is in the player. TUNE: Press this knob lightly so it extends. Turn it to choose radio stations. Push the knob back in when you're not using it. SEEK: Press the up or down arrow to go to the next higher or lower station. The sound will be muted while seeking. PUSHBUTTONS: The fivenumbered pushbuttons let you return to your favorite stations. You can set up to 15 stations (five AM, five FM1 and five FM2). 1. Press AM-FM to select the band. 2. Find the station you want by using TUNE or SEEK. 3. Press TONE to select the setting you prefer. 4. Press and hold one of the five numbered buttons. 5. The sound will mute. When it returns, release the button. Whenever you press that numbered button, the station you set will return and the TONE you selected will be automatically selected for that button. TONE: This featureallows you to choose preset treble and bass equalization settings designed for jazz,vocal, pop, rock and classical stations. JAZZ will appear on the display when you first press TONE. Each time you press it, another setting will appear on the display. Press it again after classic appears, and MANUAL will appear. Tone control will return to the TREB and BASS knobs. Also, if you use the TREB and BASS knobs, control will return to them and MANUAL will appear. SCAN: Press and release this button to listen to stations for a few seconds. The radio will go to a station, stop for a few seconds, then go on to the next station. Press SCAN again to stop scanning. The sound will be muted while scanning, and SCAN will appear on the display. If you press SCAN for more than two seconds, the radio will change to PSCAN mode. PSCAN will appear on the display. PSCAN: Press SCAN for more than two secondsfor PSCAN to appear on the display. The radio will go to the first preset station, stop for a few seconds, then to the go next preset station. Press SCAN again to stop scanning. 3-9